F6 CHECK THE RH (RIGHT-HAND) EXTERIOR MIRROR GROUND CIRCUIT FOR AN OPEN
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-7 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to F7 |
|---|---|
No | REPAIR the circuit. |
F7 CHECK THE EXTERIOR MIRROR JUMPER HARNESS
Inspect the exterior mirror jumper harness between the vehicle harness and the mirror motors for:
Open or short circuits Damaged or pushed out pins Corrosion
Is the harness OK?
Yes | INSTALL a new exterior mirror glass. REFER to: Exterior Mirror (501-09 Rear View Mirrors, Removal and Installation). |
|---|---|
No | REPAIR the harness as necessary. If the harness cannot be repaired, INSTALL a new exterior mirror. REFER to: Exterior Mirror (501-09 Rear View Mirrors, Removal and Installation). |
The LH and/or RH Power Folding Mirror Is Inoperative/Do Not Operate Correctly (if equipped)
Refer to Wiring Diagrams Cell 124 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Rear View Mirrors - System Operation and Component Description (501-09 Rear View Mirrors, Description and Operation).
Possible Causes
Binding or obstructed power folding mirror Power folding mirrors are not synchronized Power folding mirror motor lockout feature is active Wiring, terminals or connectors Power folding mirror Power folding mirror relay Exterior mirror fold switch (integral to the front door window control switch)
Visual Inspection and Diagnostic Pre-Checks
If the power folding mirrors are folded or unfolded several times continuously, the power lockout feature
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.