Rear View Mirrors — 2016 workshop reference 945

disables the system for approximately 3-10 minutes to prevent damage to the power fold motors. After 3-10 minutes have elapsed, normal operation resumes. The power folding mirrors may need to be synchronized when the LH, RH or both power folding mirrors are partially folded in toward the door manually, and then folded inward using the power folding mirror control switch. Verify that the power folding mirrors are not binding or obstructed.

PINPOINT TEST G : THE LH (LEFT-HAND) AND/OR RH (RIGHT-HAND) POWER FOLDING MIRROR IS

INOPERATIVE/ DO NOT OPERATE CORRECTLY (IF EQUIPPED)

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector. Use only Rotunda Flex Probes (NUD105- R025D)

G1 CHECK POWER FOLDING MIRROR OPERATION

Ignition ON. Press the exterior mirror folding switch to activate the power folding mirrors.

Are both power folding mirrors inoperative or do not operate correctly?

Yes	GO to G2
No	GO to G10

G2 CHECK THE EXTERIOR FOLDING MIRROR CONTROL SWITCH

Ignition OFF. Disconnect: Front Door Window Control Switch C504. Perform the appropriate component test. Refer to Wiring Diagrams Cell 149 for schematic and connector information.

Did the exterior folding mirror control switch pass the component test?

Yes	GO to G3
No	INSTALL a new exterior folding mirror control switch (integral to the front door window control switch). REFER to: Front Door Window Control Switch (501-11 Glass, Frames and Mechanisms, Removal and Installation).

Yes

GO to G3

INSTALL a new exterior folding mirror control switch (integral to the front door window control switch).

REFER to: Front Door Window Control Switch (501-11 Glass, Frames and Mechanisms, Removal and Installation).

G3 CHECK THE FOLDING MIRROR CONTROL CIRCUIT FOR A SHORT TO GROUND

Disconnect: Power Folding Mirror Relay C3276. Measure:

Click to display connectors

Positive Lead	Measurement / Action	Negative Lead
C504-2		Ground

Is the resistance greater than 10,000 ohms?

Yes	GO to G4
No	REPAIR the circuit. SYNCHRONIZE the power folding mirrors.

Source reference 945

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.