G4 CHECK THE FOLDING MIRROR CONTROL CIRCUIT FOR AN OPEN
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C504-2 | C3276-4 |
Is the resistance less than 3 ohms?
Yes | GO to G5 |
|---|---|
No | REPAIR the circuit. SYNCHRONIZE the power folding mirrors. |
G5 CHECK FOR VOLTAGE TO THE POWER MIRROR FOLD RELAY
Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3276-3 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to G6 |
|---|---|
No | VERIFY that BCM fuse 2 (7.5A) is OK. If OK, REPAIR the circuit for an open. If not OK, REFER to the Wiring Diagrams manual to identify the possible causes of the circuit short. |
G6 CHECK FOR GROUND TO THE POWER MIRROR FOLD RELAY
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3276-1 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to G7 |
|---|---|
No | REPAIR the circuit. SYNCHRONIZE the power folding mirrors. |
G7 CHECK THE POWER FOLDING MIRROR RELAY FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect: LH Exterior Mirror C520. Disconnect: RH Exterior Mirror C626.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.