MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Body & Paint

Front Seats

501-10A Front Seats

2016 MustangReference 1,020 / 6,619HTML edition
← Chapter contentsProcedure contents

Yes

INSTALL a new cushion blower motor. REFER to: Front Seat Cushion Blower Motor (501-10A Front Seats, Removal and Installation). GO to L11

No

REPAIR the circuit in question. GO to L11

L7 CHECK THE BACKREST BLOWER MOTOR CIRCUITS FOR A SHORT TO GROUND

Disconnect: Driver Seat Backrest Blower Motor C3034. Measure:

Click to display connectors

Positive Lead

Measurement / Action

Negative Lead

C3265A-J

Ground

C3265A-K

Ground

Are the resistances greater than 10,000 ohms?

Yes

INSTALL a new backrest blower motor. REFER to: Front Seat Backrest Blower Motor (501-10 Front Seats) . GO to L11

No

REPAIR the circuit in question. GO to L11

L8 CHECK THE CUSHION BLOWER MOTOR CIRCUITS FOR A SHORT TO VOLTAGE

Disconnect: Driver Seat Cushion Blower Motor C3035. Ignition ON. Measure:

Click to display connectors

Positive Lead

Measurement / Action

Negative Lead

C3265A-G

Ground

C3265A-H

Ground

Is any voltage present?

Yes

REPAIR the circuit in question. GO to L11

No

INSTALL a new cushion blower motor. REFER to: Front Seat Cushion Blower Motor (501-10A Front Seats, Removal and Installation). GO to L11

L9 CHECK THE BACKREST BLOWER MOTOR CIRCUITS FOR A SHORT TO VOLTAGE

Disconnect: Driver Seat Backrest Blower Motor C3034. Ignition ON. Measure:

Click to display connectors

Positive Lead

Measurement / Action

Negative Lead

C3265A-J

Ground

C3265A-K

Ground

Is any voltage present?

Yes

REPAIR the circuit in question. GO to L11

No

INSTALL a new backrest blower motor. REFER to: Front Seat Backrest Blower Motor (501-10 Front Seats) . GO to L11

L10 CHECK THE SCME (FRONT SEAT CLIMATE CONTROL MODULE) OPERATION

Ignition OFF. Disconnect and inspect all of the SCME connectors. Repair:

corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins as necessary pushed-out pins - install new pins as necessary

Reconnect the SCME connectors. Make sure they seat and latch correctly.

NOTE: Do not reconnect Driver Side Airbag In-line C345 or Passenger Side Airbag In-line C219 at this time.

Source reference 1020

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.