Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new DDM. REFER to: Driver Door Module (DDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
J15 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all the BCM connectors. Repair:
corrosion (install new connectors or terminals - clean module pins) damaged or bent pins - install new terminals pins pushed-out pins - install new pins as necessary
Reconnect the BCM connectors and make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
All Door Locks Are Inoperative From One Door Lock Control Switch
Refer to Wiring Diagrams Cell 117 for schematic and connector information.
Normal Operations and Fault Conditions
REFER to: Handles, Locks, Latches and Entry Systems - System Operation and Component Description (501-14 Handles, Locks, Latches and Entry Systems, Description and Operation).
Possible Cause
Wiring, terminals or connectors Door lock control switch
Visual Inspection and Diagnostic Pre-checks
Check the door lock control switch for damage
PINPOINT TEST K : ALL DOOR LOCKS ARE INOPERATIVE FROM ONE DOOR LOCK CONTROL SWITCH
K1 CHECK FOR COMMUNICATION TO THE DDM (DRIVER DOOR MODULE) AND PDM (PASSENGER DOOR MODULE)
NOTE: If the vehicle is not equipped with a memory seat, proceed to K2. Ignition ON. Using a diagnostic scan tool, perform the network test.
Do the DDM and PDM pass the network test?
Yes | GO to K2 |
|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network, Diagnosis and Testing). |
K2 CHECK THE DOOR LOCK CONTROL SWITCH GROUND CIRCUIT FOR AN OPEN
Ignition OFF. Disconnect suspect door lock control switch. Measure:
Click to display connectors
Driver Door Lock Control Switch (without memory)
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C505-3 | Ground |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.