Left Front Door
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C501A-3 | Ground |
Click to display connectors
Right Front Door
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C652A-3 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to L13 |
|---|---|
No | REPAIR the circuit. |
L13 CHECK THE DOOR LOCK INDICATOR VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
Left Front Door
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C501A-3 | C573-6 |
Click to display connectors
Right Front Door
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C652A-3 | C649-6 |
Is the resistance less than 3 ohms?
Yes | For a left front door indicator, GO to L15 For a right front door indicator, GO to L14 |
|---|---|
No | REPAIR the circuit. |
L14 CHECK FOR CORRECT PDM (PASSENGER DOOR MODULE) OPERATION
Disconnect and inspect all the PDM connectors. Repair:
corrosion (install new connectors or terminals - clean module pins) damaged or bent pins - install new terminals pins pushed-out pins - install new pins as necessary
Reconnect the PDM connectors and make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
L15 CHECK FOR CORRECT DDM (DRIVER DOOR MODULE) OPERATION
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.