N3 CHECK THE LUGGAGE COMPARTMENT LID RELEASE SWITCH INPUT CIRCUIT FOR A SHORT TO GROUND
Click to display connectors
DTC B1219:11
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2280B-1 | Ground |
Click to display connectors
DTC C1017:11
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2280E-14 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to N11 |
|---|---|
No | REPAIR the circuit. |
N4 CHECK THE LUGGAGE COMPARTMENT LID RELEASE OUTPUT USING THE DECKLID / LIFTGLASS RELEASE OUTPUT STATUS (DL_LFTGLS_RLS) PID (PARAMETER IDENTIFICATION)
Using a diagnostic scan tool, view the BCM Parameter Identifications (PIDs). Command the BCM PID DL_LFTGLS_RLS on and then off.
Does the luggage compartmnet lid latch release?
Yes | GO to N5 |
|---|---|
No | VERIFY the BCM fuse 16 (15A) is OK. If OK, GO to N8 If not OK, REFER to the Wiring Diagrams manual to identify the possible cause of the circuit short. |
N5 CHECK THE SUSPECT LUGGAGE COMPARTMENT LID RELEASE SWITCH
Ignition OFF. Disconnect Suspect luggage compartment lid release switch. Unlock the doors using a door lock control switch. Connect:
Click to display connectors
Interior Luggage Compartment Lid Release Switch
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2610-6 | C2610-2 |
Click to display connectors
Exterior Luggage Compartment Lid Release Switch
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4333-1 | C4333-2 |
Remove the fused jumper wire.
Does the luggage compartment lid latch release?
Yes | INSTALL a new luggage compartment lid release switch in question. |
|---|---|
No | GO to N6 |
N6 CHECK THE SUSPECT LUGGAGE COMPARTMENT LID RELEASE SWITCH GROUND CIRCUIT FOR AN OPEN
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.