Does the vehicle remotely start?
Yes | The system is operating correctly. INFORM the customer of the correct vehicle remote start operation. |
|---|---|
No | REPLACE the passive key in question. PROGRAM the new passive key. REFER to: Anti-Theft Security Access (419-01B Passive Anti-Theft System (PATS), General Procedures). |
R9 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all the BCM connectors. Repair:
corrosion (install new connectors or terminals - clean module pins) damaged or bent pins - install new terminals pins pushed-out pins - install new pins as necessary
Reconnect the BCM connectors and make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
A Door Passive Entry Feature Is Inoperative
Refer to Wiring Diagrams Cell 117 for schematic and connector information.
Normal Operations and Fault Conditions
REFER to: Handles, Locks, Latches and Entry Systems - System Operation and Component Description (501-14 Handles, Locks, Latches and Entry Systems, Description and Operation).
BCM DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|---|---|
B11C6:01 | Passenger Door External Antenna: General Electrical Failure | Sets when the BCM detects a fault from one of the circuits to the passenger side keyless entry antenna (internal to the front passenger exterior door handle). |
B11CA:01 Driver Door External Antenna: General Electrical Failure | Sets when the BCM detects a fault from one of the circuits to the driver side keyless entry antenna (internal to the front driver exterior door handle). | |
B1381:11 | Left Front Door Handle Proximity Sensor: Circuit Short To Ground | Sets when the BCM detects a fault from one of the circuits to the left front exterior door handle. |
B1381:15 | Left Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | Sets when the BCM detects a fault from one of the circuits to the left front exterior door handle. |
B1381:29 | Left Front Door Handle Proximity Sensor: Signal Invalid | Set when the BCM detects an activated touch sensor for more than 5 minutes. |
B1382:11 | Right Front Door Handle Proximity Sensor: Circuit Short To Ground | Sets when the BCM detects a fault from one of the circuits to the right exterior door handle. |
B1382:15 | Right Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | Sets when the BCM detects a fault from one of the circuits to the right exterior door handle. |
B1382:29 | Right Front Door Handle Proximity Sensor: Signal Invalid | Set when the BCM detects an activated touch sensor for more than 5 minutes. |
Possible Cause
Wiring, terminals or connectors Door lock system concern RKE system concern Exterior door handle BCM
Visual Inspection and Diagnostic Pre-checks
Inspect the exterior door handles for damage
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.