Left Front
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C543-2 | Ground | |
C543-3 | Ground |
Click to display connectors
Right Front
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C634-2 | Ground | |
C634-3 | Ground |
Are the resistances greater than 10,000 ohms?
Yes | GO to S15 |
|---|---|
No | REPAIR the circuit in question. |
S15 CHECK THE EXTERIOR DOOR HANDLE ANTENNA CIRCUITS FOR AN OPEN
Measure:
Click to display connectors
Left Front
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C543-2 | C2280D-13 | |
C543-3 | C2280D-28 |
Click to display connectors
Right Front
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C634-2 | C2280D-12 | |
C634-3 | C2280D-29 |
Are the resistances less than 3 ohms?
Yes | GO to S16 |
|---|---|
No | REPAIR the circuit in question. |
S16 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all the BCM connectors. Repair:
corrosion (install new connectors or terminals - clean module pins) damaged or bent pins - install new terminals pins pushed-out pins - install new pins as necessary
Reconnect the BCM connectors and make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.