DTC Description Action Installed B142D:00 Pyrotechnic End of Life INSTALL a new RCM and CARRY OUT PMI. Use As-Built data when Activation Performed: No carrying out PMI for this DTC. Sub Type Information REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation). B1469:4A Unused Satellite Restraints Sensor 1: REFER to: Pinpoint Test - DTC: AB (501-20B Supplemental Restraint Incorrect Component System, Diagnosis and Testing). Installed B146A:4A Unused Satellite Restraints Sensor 2: REFER to: Pinpoint Test - DTC: AB (501-20B Supplemental Restraint Incorrect Component System, Diagnosis and Testing). Installed B147D:11 Driver Side Hood Hinge DEPOWER the SRS. Deployment Control: REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Circuit Short to Ground Supplemental Restraint System, General Procedures). DISCONNECT RCM C310A and C310B. MEASURE the resistance between RCM C310B-7 and ground, and between RCM C310B-8 and ground. TURN ON the ignition and MEASURE the voltage between RCM C310B-7 and ground, and between RCM C310B-8 and ground. If either resistance is less than 10,000 ohms, or if any voltage is present on either circuit, REPAIR the circuit(s) as necessary. If the resistances are greater than 10,000 ohms and there is not any voltage present, INSTALL a new RCM. REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation). B147D:4A Driver Side Hood Hinge Deployment Control: REFER to: Pinpoint Test - DTC: AB (501-20B Supplemental Restraint Incorrect Component System, Diagnosis and Testing). Installed B147E:11 Passenger Side Hood DEPOWER the SRS. Hinge Deployment REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Control: Circuit Short to Supplemental Restraint System, General Procedures). Ground DISCONNECT RCM C310A and C310B. MEASURE the resistance between RCM C310B-5 and ground, and between RCM C310B-6 and ground. TURN ON the ignition and MEASURE the voltage between RCM C310B-5 and ground, and between RCM C310B-6 and ground. If either resistance is less than 10,000 ohms, or if any voltage is present on either circuit, REPAIR the circuit(s) as necessary. If the resistances are greater than 10,000 ohms and there is not any voltage present, INSTALL a new RCM. REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation). B147E:4A Passenger Side Hood Hinge Deployment REFER to: Pinpoint Test - DTC: AB (501-20B Supplemental Restraint Control: Incorrect System, Diagnosis and Testing). Component Installed B14EB:11 Pedestrian Protection Sensor Passenger REFER to: Pinpoint Test - DTC: X, Coupe (501-20B Supplemental Outer: Circuit Short to Restraint System, Diagnosis and Testing). Ground B14EB:4A Pedestrian Protection Sensor Passenger REFER to: Pinpoint Test - DTC: AB (501-20B Supplemental Restraint Outer: Incorrect System, Diagnosis and Testing). Component Installed
Original table alignment retained · Scroll horizontally if needed
Source reference 1765
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.