MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Body & Paint

Airbag Supplemental Restraint System (SRS)

501-20B Supplemental Restraint System

2016 MustangReference 1,770 / 6,619HTML edition
← Chapter contentsProcedure contents

Description

Action

DTC

U3000:54

Control Module: Missing Calibration

Using a diagnostic scan tool, CARRY OUT the OCS Reset. FOLLOW all instructions on the diagnostic scan tool. If the OCS Reset was not successful, VERIFY correct installation of the OCS. VERIFY the pressure sensor hose is correctly routed and CORRECT the installation as necessary. REPEAT the self-test. If DTC U3000:54 is still present, INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor (501-20B Supplemental Restraint System, Removal and Installation).

U3003:16

Battery Voltage: Circuit Voltage Below Threshold

REFER to: Pinpoint Test - DTC: AJ (501-20B Supplemental Restraint System, Diagnosis and Testing).

U3003:17

Battery Voltage: Circuit Voltage Above Threshold

REFER to: Pinpoint Test - DTC: AJ (501-20B Supplemental Restraint System, Diagnosis and Testing).

DTC Chart: Body Control Module (BCM)

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

OCSM DTC Chart

Description

Action

DTC

B11D8:01

Restraint Event Notification: General Electrical Failure

CARRY OUT the RCM self-test. DIAGNOSE and REPAIR the RCM Diagnostic Trouble Codes (DTCs). REFER to DTC Chart: RCM.

All other BCM Diagnostic Trouble Codes (DTCs)

–

REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing).

Symptom Chart(s)

Symptom Chart: Supplemental Restraint System

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

Symptom Chart

Condition

Possible Sources

Actions

A module does not respond to the diagnostic scan tool

Fuse Diagnostic scan tool DLC Wiring, terminals or connectors Module

REFER to: Communications Network (418-00 Module Communications Network, Diagnosis and Testing).

Source reference 1770

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.