DTC Description Action Voltage Below Threshold B00C0:49 Passenger Seat INSTALL a new OCS sensor. Occupant Classification REFER to: Occupant Classification System (OCS) Sensor (501-20B Sensor "A": Internal Supplemental Restraint System, Removal and Installation). Electronic Failure B00C0:7B Passenger Seat INSPECT the OCS for any damage and for correct installation. Occupant Classification If damage is found, REPAIR the root cause of the damage and Sensor "A": Low Fluid INSTALL a new OCS, as necessary. Level REFER to: Occupant Classification System (OCS) Sensor (501-20B Supplemental Restraint System, Removal and Installation). If any installation concerns are found, CORRECT the OCS installation, referring to the OCS Removal and Installation procedure as needed to make sure the sensor hose is correctly routed. REFER to: Occupant Classification System (OCS) Sensor (501-20B Supplemental Restraint System, Removal and Installation). If no damage or installation concerns are found, INSTALL a new OCS. REFER to: Occupant Classification System (OCS) Sensor (501-20B Supplemental Restraint System, Removal and Installation). B00C2:11 Passenger Seat Occupant Classification REFER to: Pinpoint Test - DTC: AL (501-20B Supplemental Restraint Sensor "C": Circuit Short System, Diagnosis and Testing). to Ground B00C2:12 Passenger Seat Occupant Classification REFER to: Pinpoint Test - DTC: AL (501-20B Supplemental Restraint Sensor "C": Circuit Short System, Diagnosis and Testing). to Battery B1193:00 Crash Event Storage Full CLEAR the OCSM Diagnostic Trouble Codes (DTCs) and REPEAT the and Locked: No Sub self-test. If DTC B1193:00 returns, INSTALL a new OCS sensor. Type Information INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor (501-20B Supplemental Restraint System, Removal and Installation). U0100:00 Lost Communication with ECM/PCM A: No Sub REFER to: Pinpoint Test - DTC: AD (501-20B Supplemental Restraint Type Information System, Diagnosis and Testing). U0151:00 Lost Communication with Restraints Control REFER to: Pinpoint Test - DTC: AM (501-20B Supplemental Restraint Module: No Sub Type System, Diagnosis and Testing). Information U0401:00 Invalid Data Received CARRY OUT the PCM self-test. REFER to the appropriate workshop from ECM/PCM A: No manual section. Refer to the appropriate section in Group 303 for the Sub Type Information procedure. U3000:41 Control Module: General INSTALL a new OCS sensor. Checksum Failure REFER to: Occupant Classification System (OCS) Sensor (501-20B Supplemental Restraint System, Removal and Installation). U3000:42 Control Module: General INSTALL a new OCS sensor. Memory Failure REFER to: Occupant Classification System (OCS) Sensor (501-20B Supplemental Restraint System, Removal and Installation). U3000:46 Control Module: INSTALL a new OCS sensor. Calibration / Parameter REFER to: Occupant Classification System (OCS) Sensor (501-20B Memory Failure Supplemental Restraint System, Removal and Installation).
Original table alignment retained · Scroll horizontally if needed
Source reference 1769
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.