Pinpoint Test - DTC: P — 2016 workshop reference 1908

Disconnect Passenger Seat Position Sensor C3240. Ignition ON. Using a diagnostic scan tool, perform RCM self-test. DIAGNOSTIC TIP: When viewing Diagnostic Trouble Codes (DTCs) with the passenger seat track position sensor disconnected, an open circuit fault is normally retrieved.

Did the on-demand DTC change from B00C5:11 or B00C5:1D to B00C5:13?

Yes	GO to A8
No	For DTC B00C5:11, GO to A3 For DTC B00C5:1D, GO to A9

A3 CHECK THE PASSENGER SEAT TRACK POSITION SENSOR CIRCUIT FOR A SHORT TO GROUND

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect RCM C310A and C310B. Measure:

Click to display connectors

Positive Lead	Measurement / Action	Negative Lead
C3240-2		Ground

Is the resistance greater than 10,000 ohms?

Yes	GO to A9
No	REPAIR the circuit. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A11

A4 CHECK THE PASSENGER SEAT TRACK POSITION SENSOR CIRCUIT FOR A SHORT TO VOLTAGE

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect RCM C310A and C310B. Disconnect Passenger Side Airbag (Inline) C219. Disconnect Passenger Seat Position Sensor C3240. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Measure:

Click to display connectors

Positive Lead	Measurement / Action	Negative Lead
C3240-2		Ground

Source reference 1908

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.