No | In the process of diagnosing the fault, the fault condition has become intermittent. Do not install any new SRS components at this time. Install SRS components only when directed to do so in the pinpoint test. GO to A10 |
|---|
A9 CONFIRM THE RCM (RESTRAINTS CONTROL MODULE) FAULT
NOTE: Make sure all SRS components and the RCM electrical connectors are connected before carrying out the self-test. If not, Diagnostic Trouble Codes (DTCs) will be recorded.
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Prior to reconnecting any previously disconnected SRS component:
inspect connector(s) (including any inline connectors) for pushed-out, loose or spread terminals and loose or frayed wire connections at terminals. inspect wire harness for any damaged, pinched, cut or pierced wires. inspect RCM C310A and C310B Connector Position Assurance (CPA) lever/lock for correct operation. repair any concerns found. Refer to Wiring Diagrams Cell 5 for schematic and connector information.
Connect RCM C310A and C310B (if previously disconnected). Connect Passenger Side Airbag (Inline) C219 (if previously disconnected). Connect Passenger Seat Position Sensor C3240. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test.
Was the original DTC retrieved on-demand during self-test?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new RCM. REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation). GO to A11 | |
|---|---|---|
No | In the process of diagnosing the fault, the fault condition has become intermittent. Do not install any new SRS components at this time. Install SRS components only when directed to do so in the pinpoint test. GO to A10 | |
A10 CHECK FOR AN INTERMITTENT FAULT
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect Passenger Seat Position Sensor C3240.
Inspect connector(s) (including any inline connectors) for corrosion, loose or spread terminals and loose or frayed wire connections at terminals. Inspect wire harness for any damage, pinched, cut or pierced wires. Inspect RCM C310A and C310B Connector Position Assurance (CPA) lever/lock for correct operation. Repair any concerns found. Refer to Wiring Diagrams Cell 5 for schematic and connector information.
Connect all previously disconnected component(s) / connector(s). Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System,
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.