Is the resistance less than 0.5 ohm?
Yes | GO to A7 | |
|---|---|---|
No | REPAIR the circuit. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A11 | |
A7 CHECK THE PASSENGER SEAT TRACK POSITION SENSOR GROUND CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3240-1 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to A9 | |
|---|---|---|
No | REPAIR the circuit. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A11 | |
A8 CONFIRM THE PASSENGER SEAT TRACK POSITION SENSOR FAULT
NOTE: Make sure all SRS components and the RCM electrical connectors are connected before carrying out the self-test. If not, Diagnostic Trouble Codes (DTCs) will be recorded.
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Prior to reconnecting any previously disconnected SRS component:
inspect connector(s) (including any inline connectors) for pushed-out, loose or spread terminals and loose or frayed wire connections at terminals. inspect wire harness for any damaged, pinched, cut or pierced wires. inspect RCM C310A and C310B Connector Position Assurance (CPA) lever/lock for correct operation. repair any concerns found. Refer to Wiring Diagrams Cell 5 for schematic and connector information.
Connect Passenger Side Airbag (Inline) C219 (if previously disconnected). Connect Passenger Seat Position Sensor C3240. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test.
Was the original DTC retrieved on-demand during self-test?
Yes | INSTALL a new passenger seat track position sensor. REFER to: Seat Position Sensor (501-20B Supplemental Restraint System, Removal and Installation). GO to A11 |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.