Is any voltage present?
Yes | REPAIR the circuit. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A11 |
|---|---|
No | GO to A9 |
A5 CHECK THE PASSENGER SEAT TRACK POSITION SENSOR DTC (DIAGNOSTIC TROUBLE CODE) FOR A FAULT STATUS CHANGE (OPEN INDICATED)
NOTE: This pinpoint test step attempts to change the fault reported by the RCM by inducing a different fault condition. If the reported fault changes, this indicates the RCM is functioning correctly and is not the source of the fault.
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect Passenger Side Airbag (Inline) C219. Disconnect Passenger Seat Position Sensor C3240. Connect a fused jumper wire:
Click to display connectors
Lead 1 | Measurement / Action | Lead 2 |
|---|---|---|
C3240-2 | C3240-1 |
Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test. DIAGNOSTIC TIP: When viewing Diagnostic Trouble Codes (DTCs) with the passenger seat track position sensor circuits shorted together, a short to ground fault is normally retrieved.
Did the on-demand DTC change from B00C5:13 to B00C5:11?
Yes | REMOVE the fused jumper wire and GO to A8 |
|---|---|
No | REMOVE the fused jumper wire and GO to A6 |
A6 CHECK THE PASSENGER SEAT TRACK POSITION SENSOR CIRCUIT FOR AN OPEN
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect RCM C310A and C310B. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C310B-24 | C3240-2 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.