6. Metal finish the repair area using typical metal finishing techniques.
7. Apply a Ford approved primer to the repair area.
8. NOTE: Apply seam sealer after priming the area.
Sealing work: All areas must be sealed to production level. Material : Seam Sealer / TA-2-B
9. Refinish using a Ford approved paint system.
10. Restore corrosion protection. Refer to: Corrosion Prevention (501-25 Body Repairs - General Information, General Procedures).
11. Install the front door hinges to the A-pillar.
12. Reposition the carpet and wiring harness.
13. Install the following items:
1. Refer to: A-Pillar Trim Panel - Coupe (501-05 Interior Trim and Ornamentation, Removal and Installation). Refer to: A-Pillar Trim Panel - Convertible (501-05 Interior Trim and Ornamentation, Removal and Installation).
2. Refer to: Fender (501-02 Front End Body Panels, Removal and Installation).
3. Refer to: Front Door (501-03 Body Closures, Removal and Installation).
4. Refer to: Rocker Panel Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).
5. NOTE: Coupe only.
Refer to: Roof Panel (501-28 Roof Sheet Metal Repairs, Removal and Installation).
6.
7. Refer to: Hood (501-02 Front End Body Panels, Removal and Installation).
14. Align the hood as necessary. Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
Copyright © 2016 Ford Motor Company
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.