Engine Mount LH

303-01C Engine - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS) 2016 Mustang

Removal and Installation Procedure revision date: 02/10/2015

Base Part Number: 6038

Special Tool(s) / General Equipment

Engine Mount LH — original illustration 1, reference 228Original colors & callouts · Select to enlarge	303-050 (T70P-6000) Lifting Bracket, Engine
Engine Mount LH — original illustration 2, reference 228Original colors & callouts · Select to enlarge	303-F072 Support Bar, Engine

Removal

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).

2. Disconnect the battery ground and positive cables. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

3. If equipped with a strut tower cross brace, detach the wiring harness retainer. Remove the nuts and the strut tower cross brace.

Engine Mount LH — original illustration 3, reference 228Original colors & callouts · Select to enlarge

4. NOTE: The engine appearance cover rubber grommets may remain on the cover. If so, remove the grommets from the cover and install them on the intake manifold before installing the cover.

Remove the engine appearance cover.

Source reference 228

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.