Condition | Possible Sources | Actions |
|---|---|---|
Driveline vibration - occurs at cruising speeds | Binding or damaged CV joint | CHECK the outer CV joint for correct seating into the hub. REPAIR as necessary. REFER to: Rear Halfshaft (205-05 Rear Drive Halfshafts, Removal and Installation). REFER to: Wheel Bearing and Wheel Hub (204-02 Rear Suspension, Removal and Installation). |
Differential Seals
NOTICE: When installing shafts, do not allow splines to contact seals during installation or damage to the seals may occur.
Halfshaft seals are susceptible to the same types of damage as drive pinion seals if incorrectly installed. The seal bore must be clean and the lip handled carefully to avoid cutting or tearing it. The seal journal surface must be free of nicks, gouges and rough surface texture.
For information on differential seals, REFER to: Rear Halfshaft Seal (205-02 Rear Drive Axle/Differential, Removal and Installation).
Copyright © 2016 Ford Motor Company
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.