Tie Rod End
Base Part Number: 3304
Special Tool(s) / General Equipment
Tie Rod End Remover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. NOTICE: Disconnect the battery ground cable anytime the steering linkage is being serviced or
damage to the steering gear may occur resulting in steering gear replacement.
Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
2. Remove the wheel and tire. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Step 3
1. Loosen the tie rod end jam nut. Torque : 76 lb.ft (103 Nm)
2. Remove and discard the outer tie rod end nut. Torque : Non SVT: 59 lb.ft (80 Nm) SVT: 30 lb.ft (40 Nm)
3. NOTICE: Do not use a hammer to separate the outer tie-rod end from the wheel spindle or
damage to the wheel spindle may result.
NOTICE: Use care when installing the tie rod separator or damage to the outer tie-rod end boot may occur.
Separate the outer tie rod end from the wheel spindle. Use the General Equipment: Tie Rod End Remover
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.