DTC | Description | Fault Trigger Conditions |
|---|---|---|
B11E6:14 Right HVAC Damper Position Sensor: Circuit Short to Ground or Open | This DTC sets when the module senses less than 1 volt on the actuator feedback circuit, indicating an open circuit or a short to ground. |
Possible Sources
Wiring, terminals or connectors Passenger side temperature door actuator FCIM
PINPOINT TEST J : THE TEMPERATURE CONTROL IS INOPERATIVE OR DOES NOT
OPERATE CORRECTLY - PASSENGER SIDE
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
J1 CHECK THE PASSENGER SIDE TEMPERATURE DOOR ACTUATOR CIRCUITS FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect Air distribution door actuator C232. Disconnect In-vehicle temperature and humidity sensor C233. Disconnect Driver side temperature door actuator C2091. Disconnect Air inlet door actuator C282. Disconnect Passenger side temperature door actuator C2092. Ignition ON. Disconnect FCIM C2402A. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2092-1 | Ground | |
C2092-2 | Ground | |
C2092-3 | Ground | |
C2092-5 | Ground | |
C2092-6 | Ground |
Is any voltage present?
Yes | REPAIR the circuit. | |
|---|---|---|
No | GO to J2 | |
J2 CHECK THE PASSENGER SIDE TEMPERATURE DOOR ACTUATOR CIRCUITS FOR A SHORT TO GROUND
Connect FCIM C2402A. Ignition OFF. Disconnect FCIM C2402A. Measure:
Click to display connectors
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.