Air Conditioning (A/C) Compressor - 5.0L 32V Ti-VCT
Base Part Number: 19D629
Removal
NOTICE: If installing a new A/C compressor due to an internal failure of the old unit, carry out the following procedures to remove contamination from the A/C system. Failure to remove contamination from the A/C system, if present, will result in poor A/C performance and/or damage to the new A/C compressor and other components.
If A/C flushing equipment is available, carry out flushing of the A/C system prior to installing a new A/C compressor. If A/C flushing equipment is not available, replace all contaminated components after a new A/C compressor has been installed. Install a new Thermostatic Expansion Valve (TXV) as directed by the A/C flushing. Install a new receiver drier element as directed by the A/C flushing.
NOTE: Installation of a new receiver drier element is not required when repairing the A/C system except when there is physical evidence of system contamination from a failed A/C compressor or damage to the receiver drier element.
NOTE: A new A/C compressor may come equipped with an A/C clutch disc and hub, A/C compressor pulley and A/C clutch field coil already installed. If these components are not pre-installed, it will be necessary to transfer these parts from the old A/C compressor to the new compressor prior to installation of the A/C compressor if suitable for reuse.
NOTE: Removal steps in this procedure may contain installation details.
1. Recover the refrigerant. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging (412-00 Climate Control System - General Information, General Procedures).
2. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
3. Remove the A/C compressor belt. Refer to: Air Conditioning (A/C) Compressor Belt (303-05C Accessory Drive - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS), Removal and Installation).
4. Remove transmission fluid cooler tubes. Refer to: Transmission Fluid Cooler Tubes - 5.0L 32V Ti-VCT (307-02A Transmission Cooling - 6-Speed Automatic Transmission - 6R80, Removal and Installation).
5. NOTE: Discard the O-ring seals and gaskets.
NOTE: Make sure that all openings are sealed.
Remove the wiring harness retainers and disconnect the electrical connector. Remove the nuts and disconnect the A/C compressor inlet and outlet lines. Torque : 159 lb.in (18 Nm)
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.