I2 CHECK THE BATTERY CURRENT SENSOR
Are any of these conditions found during inspection?
Yes | REPAIR as necessary. GO to I14 |
|---|---|
No | GO to I3 |
I3 CHECK THE BATTERY CURRENT SENSOR REFERENCE VOLTAGE CIRCUIT
Ignition OFF. Disconnect Battery current sensor C1646. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1646-1 | Ground |
Is the voltage between 4.8 and 5.2 volts?
Yes | GO to I7 |
|---|---|
No | If the voltage is less than 4.8 volts, GO to I5If the voltage is greater than 5.2 volts, GO to I4 |
I4 CHECK THE BATTERY CURRENT SENSOR REFERENCE VOLTAGE CIRCUIT FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect BCM C2280F. Using the Terminal Release Kit, release and temporarily remove BCM C2280F-3. Connect BCM C2280F. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1646-1 | Ground |
Is any voltage present?
Yes | REPAIR the circuit. |
|---|---|
No | INSTALL C2280F-3 and GO to I15 |
I5 CHECK THE BATTERY CURRENT SENSOR REFERENCE VOLTAGE CIRCUIT FOR A SHORT TO GROUND
Ignition OFF. Disconnect BCM C2280F. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1646-1 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to I6 |
|---|---|
No | REPAIR the circuit. |
I6 CHECK THE BATTERY CURRENT SENSOR REFERENCE VOLTAGE CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.