Description | Action | |||
|---|---|---|---|---|
DTC | ||||
U0452:82 | Invalid Data Received From Restraints Control Module: Alive / Sequence Counter Incorrect / Not Updated | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the RCM. REFER to: Airbag Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, Diagnosis and Testing). • If no Diagnostic Trouble Codes (DTCs) are present in the RCM, DIAGNOSE the observable symptom. | ||
U1000:00 | Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | NOTE: The FCIM has temporarily disabled a HVAC control output because an excessive current draw exists (such as a short to ground). The FCIM cannot enable the output until the cause of the short is corrected. ADDRESS all other FCIM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U1000:00 is retrieved again, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation). | ||
U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incorrect or incomplete FCIM configuration. Using a diagnostic scan tool, PERFORM the FCIM programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01 Module Configuration) . See As-Built Data. | ||
U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation). | ||
U3000:49 | Control Module: Internal Electronic Failure | ADDRESS all other FCIM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:49 is retrieved again, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation). | ||
U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AQ | ||
U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AR | ||
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.