DTC Chart: SCCM

U2101:00 Control Module Configuration

Incompatible: No Sub Type Information

This DTC sets due to an incorrect or incomplete GPSM configuration. Using a diagnostic scan tool, PERFORM the GPSM programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01 Module Configuration) . See As-Built Data.

U3000:09 Control Module: Component

Failure

CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:09 is retrieved again, DISCONNECT the battery for 1 minute, then reconnect it. CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:09 is retrieved again, INSTALL a new GPSM. REFER to: Global Positioning System Module (GPSM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation).

U3000:41 Control Module: General

Checksum Failure

CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new GPSM. REFER to: Global Positioning System Module (GPSM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation).

U3000:42 Control Module: General Memory

Failure

CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new GPSM. REFER to: Global Positioning System Module (GPSM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation).

U3003:16 Battery Voltage: Circuit Voltage

Below Threshold

GO to Pinpoint Test AQ

U3003:17 Battery Voltage: Circuit Voltage

Above Threshold

GO to Pinpoint Test AR

DTC

B1380:09

Steering Wheel Right Switch Pack: Component Failure

For a RH lower steering wheel switch concern, GO to Pinpoint Test X For a RH upper steering wheel switch concern, GO to Pinpoint Test Y