RH Front Parking Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1042-2 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to A26 | |
|---|---|---|
No | REPAIR the circuit. After the repair: If no Diagnostic Trouble Codes (DTCs) are present, TEST the system for normal operation. If DTC U1000:00 is present, CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test (required to enable the lamp output driver if DTC U1000:00 is present). If DTC U3000:49 is present, Click here to access Guided Routine (BCM). | |
A18 CHECK FOR VOLTAGE TO THE LICENSE PLATE OR REAR SIDE MARKER LAMP
Place the headlamp switch in the OFF position. Ignition OFF. Disconnect: Inoperative LH License Plate Lamp C4046A or RH License Plate Lamp C4046B. Disconnect: Inoperative LH Rear Side Marker Lamp C481 or RH Rear Side Marker Lamp C482. Ignition ON. Place the headlamp switch in the PARKING LAMPS position. Measure:
Click to display connectors
LH License Plate Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4046A-2 | Ground |
Click to display connectors
RH License Plate Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4046B-2 | Ground |
Click to display connectors
LH Rear Side Marker Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C481-2 | Ground |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.