Is the voltage greater than 11 volts?
Yes | INSTALL a new license plate bulb or rear side marker lamp bulb. REFER to: Side Lamp Bulb (417-01 Exterior Lighting, Removal and Installation). |
|---|---|
No | REPAIR the circuit. |
A20 CHECK THE LICENSE PLATE OR REAR SIDE MARKER LAMP SUPPLY CIRCUIT FOR AN OPEN
Place the headlamp switch in the OFF position. Ignition OFF. Disconnect: BCM C2280C. Measure:
Click to display connectors
LH License Plate Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4046A-2 | C2280C-12 |
Click to display connectors
RH License Plate Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4046B-2 | C2280C-12 |
Click to display connectors
LH Rear Side Marker Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C481-2 | C2280C-12 |
Click to display connectors
RH Rear Side Marker Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C482-2 | C2280C-12 |
Is the resistance less than 3 ohms?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.