Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C415-2 | Ground |
Is the voltage greater than 11 volts?
Yes | INSTALL a new rear lamp assembly. REFER to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation). |
|---|---|
No | GO to A23 |
A23 REPEAT THE ON-DEMAND SELF-TEST AND CHECK FOR VOLTAGE TO THE REAR PARKING LAMP
Place the headlamp switch in the OFF position. Using a diagnostic scan tool, perform the BCM self-test. Clear the Diagnostic Trouble Codes (DTCs) and repeat the self-test (required to enable the lamp output driver if DTC U1000:00 is present). Place the headlamp switch in the PARKING LAMPS position. Except China, measure:
Click to display connectors
LH Rear Lamp (Except China)
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C498-2 | Ground |
Click to display connectors
RH Rear Lamp (Except China)
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C499-2 | Ground |
China only, measure:
Click to display connectors
LH Rear Lamp (China Only)
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C412-2 | Ground |
Click to display connectors
RH Rear Lamp (China Only)
Positive Lead | Measurement / Action | Negative Lead |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.