Stoplamps

DTC

U1000:00

Solid State Driver Protection Active -Driver Disabled: No Sub Type Information

The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCMB cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test.

U3000:49

Control Module: Internal Electronic Failure

The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCMB can withstand. The cause of the excessive current draw MUST be corrected before a new BCMB is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, INSTALL a new BCMB. REFER to: Body Control Module B (BCMB) (419-10 Multifunction Electronic Modules, Removal and Installation).

For other BCMB Diagnostic Trouble Codes (DTCs)

-

REFER to: Body Control Module B (BCMB) (419-10 Multifunction Electronic Modules, Diagnosis and Testing).

A module does not respond to the diagnostic scan tool

Fuse Wiring, terminals or connectors Module

REFER to: Communications Network (418-00 Module Communications Network) .

All the stoplamps are inoperative

Refer to the Pinpoint Test

GO to Pinpoint Test A

One or more stoplamps are inoperative or always on - except China

Refer to the Pinpoint Test

GO to Pinpoint Test B

One or more stoplamps are inoperative or always on - China only

Refer to the Pinpoint Test

GO to Pinpoint Test C

The stoplamps are on continuously

Refer to the Pinpoint Test

GO to Pinpoint Test D