No | INSTALL a new wiring harness. REPOWER the Supplemental Restraint System (SRS). REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). |
|---|
D2 CHECK THE RCM (RESTRAINTS CONTROL MODULE) VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
Repower the SRS. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C310A-19 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to D3 |
|---|---|
No | VERIFY the BCM fuse 35 (5A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams manual to identify the possible causes of the circuit short. |
D3 CHECK THE RCM (RESTRAINTS CONTROL MODULE) CASE GROUND
Ignition OFF. Measure the resistance between the RCM case and a good chassis ground.
Is the resistance less than 3 ohms?
Yes | GO to D4 |
|---|---|
No | REPAIR the RCM case ground as necessary. |
D4 CHECK THE HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) CIRCUITS BETWEEN THE RCM (RESTRAINTS CONTROL MODULE) AND THE DLC (DATA LINK CONNECTOR) FOR AN OPEN
Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C310B-48 | C251-3 | |
C310B-47 | C251-11 |
Are the resistances less than 3 ohms?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.