Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3043-1 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to E2 |
|---|---|
No | VERIFY the BCM fuse 22 (5A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams manual to identify the possible causes of the circuit short. |
E2 CHECK THE OCSM (OCCUPANT CLASSIFICATION SYSTEM MODULE) GROUND CIRCUIT FOR AN OPEN
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3043-4 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to E3 |
|---|---|
No | REPAIR the circuit. |
E3 CHECK THE HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) CIRCUITS BETWEEN THE OCSM (OCCUPANT CLASSIFICATION SYSTEM MODULE) AND THE DLC (DATA LINK CONNECTOR) FOR AN OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3043-2 | C251-3 | |
C3043-3 | C251-11 |
Are the resistances less than 3 ohms?
Yes | GO to E4 |
|---|---|
No | REPAIR the circuit in question. |
E4 CHECK FOR CORRECT OCSM (OCCUPANT CLASSIFICATION SYSTEM MODULE) OPERATION
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.