Yes | GO to F3 |
|---|---|
No | GO to F2 |
F2 CHECK THE HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) CIRCUITS BETWEEN THE SCCM (STEERING COLUMN CONTROL MODULE) AND THE DLC (DATA LINK CONNECTOR) FOR AN OPEN
Disconnect SCCM C226A Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C226A-3 | C251-3 | |
C226A-4 | C251-11 |
Are the resistances less than 3 ohms?
Yes | GO to F5 |
|---|---|
No | REPAIR the circuit in question. |
F3 CHECK THE SCCM (STEERING COLUMN CONTROL MODULE) VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
Disconnect SCCM C226A Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C226A-7 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to F4 |
|---|---|
No | VERIFY the BCM fuse 13 (7.5A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams manual to identify the possible causes of the circuit short. |
F4 CHECK THE SCCM (STEERING COLUMN CONTROL MODULE) GROUND CIRCUIT FOR AN OPEN
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C226A-5 | Ground |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.