AE14 CHECK FOR RESTORED COMMUNICATION WITH THE ABS (ANTI-LOCK BRAKE SYSTEM) MODULE DISABLED
NOTE: When re-running the network test, close the network test application first or the screen display reverts back to the prior network test results.
Disconnect: BJB fuses 5 (20A), 28 (30A) and 62 (5A). Using a diagnostic scan tool, perform the network test.
Do all other modules pass the network test?
Yes | INSTALL the removed fuses. GO to Pinpoint Test B |
|---|---|
No | INSTALL the removed fuses. GO to AE15 |
AE15 VERIFY VEHICLE EQUIPMENT - ADAPTIVE CRUISE CONTROL OR VEHICLE DYNAMICS SYSTEM
Inspect the vehicle for an adaptive cruise control system or a vehicle dynamics system.
Is the vehicle equipped with adaptive cruise control or vehicle dynamics?
Yes | GO to AE16 |
|---|---|
No | GO to AE18 |
AE16 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE CRUISE CONTROL MODULE (CCM), HEAD UP DISPLAY (HUD) MODULE OR VEHICLE DYNAMICS MODULE (VDM) DISABLED
NOTE: When re-running the network test, close the network test application first or the screen display reverts back to the prior network test results.
Disconnect: BJB fuse 66 (5A) to disable the HUD module and CCM (if equipped). Disconnect: BJB fuse 66 (5A) and BCM fuse 25 (30A) to disable the VDM (if equipped). Using a diagnostic scan tool, perform the network test.
Do all other HS-CAN2 modules pass the network test?
Yes | INSTALL the removed fuse. GO to AE17 |
|---|---|
No | INSTALL the removed fuse. GO to AE18 |
AE17 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE HEAD UP DISPLAY (HUD) MODULE AND VEHICLE DYNAMICS MODULE (VDM) DISCONNECTED
NOTE: When re-running the network test, close the network test application first or the screen display reverts back to the prior network test results.
Disconnect: HUD module C2395 (if equipped). Using a diagnostic scan tool, perform the network test. Disconnect: VDM C4396 (if equipped). Using a diagnostic scan tool, perform the network test.
Do all other HS-CAN2 modules pass the network test?
Yes | If communication was restored with the HUD disconnected, CONNECT the HUD module. GO to Pinpoint Test Z If communication was restored with the VDM disconnected, CONNECT the VDM. GO to Pinpoint Test C |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.