Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C930-1 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to B3 |
|---|---|
No | VERIFY the BCM fuse 18 (5A) is OK. If OK, GO to B2 If not OK, REFER to the Wiring Diagrams manual to identify the possible cause of the circuit short. |
B2 CHECK THE INTRUSION SENSOR VOLTAGE SUPPLY CIRCUIT FOR A OPEN
Disconnect BCM C2280A. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C930-1 | C2280A-12 |
Is the resistance less than 3 ohms?
Yes | GO to B8 |
|---|---|
No | REPAIR the circuit. |
B3 CHECK THE INTRUSION SENSOR GROUND CIRCUIT FOR A OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C930-1 | C930-5 |
Is the voltage greater than 11 volts?
Yes | GO to B4 |
|---|---|
No | REPAIR the circuit. |
B4 CHECK THE INTRUSION SENSOR LIN (LOCAL INTERCONNECT NETWORK) CIRCUIT FOR A SHORT TO VOLTAGE
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.