Cruise Control — 2016 workshop reference 6058

Yes		GO to C5
No		REPAIR the circuit.

C5 CHECK FOR CORRECT PCM (POWERTRAIN CONTROL MODULE) OPERATION

Ignition OFF. Disconnect and inspect all PCM connectors. Repair:

corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary

Reconnect the PCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new PCM. For 2.3L, REFER to: Powertrain Control Module (PCM) (303-14A Electronic Engine Controls - 2.3L EcoBoost (231kW/314PS), Removal and Installation). For 3.7L, REFER to: Powertrain Control Module (PCM) (303-14B Electronic Engine Controls - 3.7L Duratec (227kW/301PS), Removal and Installation). For 5.0L, REFER to: Powertrain Control Module (PCM) (303-14C Electronic Engine Controls - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS), Removal and Installation). For 5.2L, REFER to: Powertrain Control Module (PCM) (303-14D Electronic Engine Controls - 5.2L 32V Ti-VCT, Removal and Installation).
No		The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new PCM. For 2.3L, REFER to: Powertrain Control Module (PCM) (303-14A Electronic Engine Controls - 2.3L EcoBoost (231kW/314PS), Removal and Installation).

For 3.7L, REFER to: Powertrain Control Module (PCM) (303-14B Electronic Engine Controls - 3.7L Duratec (227kW/301PS), Removal and Installation).

For 5.0L, REFER to: Powertrain Control Module (PCM) (303-14C Electronic Engine Controls - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS), Removal and Installation).

For 5.2L, REFER to: Powertrain Control Module (PCM) (303-14D Electronic Engine Controls - 5.2L 32V Ti-VCT, Removal and Installation).

The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

P0833 Or P170A

Refer to Wiring Diagrams Cell 31 for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Cruise Control - System Operation and Component Description (419-03A Cruise Control, Description and Operation).

DTC Fault Trigger Condition- PCM

DTC	Description	Fault Trigger Conditions

P0833 Clutch Pedal Switch A DTC that sets when the PCM receives the vehicle speed input, indicating

"B" Circuit movement and does not detect the switching input signal from the clutch pedal

Source reference 6058

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.