Cruise Control

REFER to: Cruise Control Module (CCM) (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Removal and Installation).

U3000:42

Control Module: General Memory Failure

CLEAR the Diagnostic Trouble Codes (DTCs). RETEST the adaptive cruise control system. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new CCM. REFER to: Cruise Control Module (CCM) (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Removal and Installation).

U3000:44

Control Module: Data Memory Failure

CLEAR the Diagnostic Trouble Codes (DTCs). RETEST the adaptive cruise control system. REPEAT the self-test. If DTC U3000:44 is retrieved again, INSTALL a new CCM. REFER to: Cruise Control Module (CCM) (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Removal and Installation).

U3000:49

Control Module: Internal Electronic Failure

CLEAR the Diagnostic Trouble Codes (DTCs). RETEST the adaptive cruise control system. REPEAT the self-test. If DTC U3000:49 is retrieved again, INSTALL a new CCM. REFER to: Cruise Control Module (CCM) (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Removal and Installation).

U3000:63

Control Module: Circuit/Component Protection Time-Out

GO to Pinpoint Test P

U3002:62

Vehicle Identification Number: Signal Compare Failure

This DTC sets when the stored VIN in the CCM does not match the VIN defined in the BCM. This may indicate that the original CCM is not installed in the vehicle, and has not been configured correctly. CARRY OUT the PMI (when the original module is not available) for the module in question as directed by the diagnostic scan tool.

U3003:16

Battery Voltage: Circuit Voltage Below Threshold

GO to Pinpoint Test Q

U3003:17

Battery Voltage: Circuit Voltage Above Threshold

GO to Pinpoint Test R

U0405:41

Invalid Data Received From Cruise Control Module: General Checksum Failure

This DTC sets when the ABS module receives invalid network data from the CCM. RETRIEVE and REPAIR all non network diagnostic trouble codes (DTCs) in the CCM.

U0405:82

Invalid Data Received From Cruise Control Module: Alive/Sequence Counter Incorrect/Not Updated

This DTC sets when the ABS module receives invalid network data from the CCM. RETRIEVE and REPAIR all non-network diagnostic trouble codes (DTCs) in the CCM.

U2107:00

Collision Mitigation By Braking: No Sub Type Information

This DTC sets in the ABS module due to long and too frequent collision mitigation brake requests from the CCM RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the CCM and other modules on the network.

U2107:68

Collision Mitigation By Braking: Event Information

This DTC is set in the ABS module due to a high acceleration value detected that differs from request, which can be caused by an abrupt vehicle stop or module failure. RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) in the CCM and ABS module.