Cruise Control

U2108:00

Adaptive Cruised Control: No Sub Type Information

This DTC sets in the ABS module when the adaptive cruise control does not switch off while the driver is braking. RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) in the CCM and ABS module.

U2108:68

Adaptive Cruise Control: Event Information

This DTC is set in the ABS module when the module detects over-braking during automated vehicle deceleration. If the vehicle deceleration exceeds the 3.2 m/s² threshold, the DTC is stored and the adaptive cruise control is deactivated until the next ignition cycle. RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) in the CCM and ABS module.

All other Diagnostic Trouble Codes (DTCs)

–

REFER to: Anti-Lock Brake System (ABS) and Stability Control (206-09 Anti-Lock Brake System (ABS) and Stability Control, Diagnosis and Testing).

A module does not communicate with the diagnostic scan tool

Fuse Wiring, terminals or connectors Communication concern Module

REFER to: Communications Network (418-00 Module Communications Network) .

The adaptive cruise control is inoperative

Refer to the Pinpoint Test

GO to Pinpoint Test A

The cruise control switch is inoperative/does not operate correctly

Refer to the Pinpoint Test

GO to Pinpoint Test A

The adaptive cruise control does not disengage when the clutch pedal is applied

Refer to the Pinpoint Test

GO to Pinpoint Test C

The adaptive cruise control does not function in rain or snow conditions

Refer to the Pinpoint Test

GO to Pinpoint Test I

ADAPTIVE CRUISE NOT AVAILABLE SENSOR BLOCKED SEE MANUAL message in the IPC message center

Refer to the Pinpoint Test

GO to Pinpoint Test I

The adaptive cruise control indicator lamp is never/ always on

Wiring, terminals and connectors PCM IPC

REFER to: Instrumentation, Message Center and Warning Chimes (413-01 Instrumentation, Message Center and Warning Chimes) .