Yes | GO to F2 |
|---|---|
No | The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
F2 CHECK THE COMMUNICATION NETWORK
Ignition ON. Using a diagnostic scan tool, perform the network test.
Does the CCM pass the network test?
Yes | GO to F3 |
|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network) . |
F3 CHECK THE CCM (CRUISE CONTROL MODULE) FOR BATTERY VOLTAGE OUT-OF-RANGE DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, perform the CCM self-test.
Is DTC U3003:16 or DTC U3003:17 recorded?
Yes | For DTC U3003:16, GO to Pinpoint Test Q For DTC U3003:17, GO to Pinpoint Test R |
|---|---|
No | GO to F4 |
F4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, retrieve the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes | REFER to: Communications Network (418-00 Module Communications Network) . |
|---|---|
No | GO to F5 |
F5 RECHECK THE PCM (POWERTRAIN CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
Clear all Diagnostic Trouble Codes (DTCs). Ignition OFF. Ignition ON. Wait 10 seconds. Using a diagnostic scan tool, perform the PCM self-test.
Is DTC U0104 still present?
Yes | GO to F6 |
|---|---|
No | The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.