Blind Spot Information System
DTC Chart(s)
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
SODL and SODR DTC Chart
DTC | Description | Action |
B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to Pinpoint Test D |
B11D6:15 Driver Display Alert LED: Circuit Short To Battery or Open | If the LH or RH Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) LED is inoperative, GO to Pinpoint Test D If the LH or RH Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) LED is always on, GO to Pinpoint Test C | |
U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test G |
U0101:00 | Lost Communication with TCM: No Sub Type Information | GO to Pinpoint Test H |
U0146:00 | Lost Communication with Gateway "A": No Sub Type Information | GO to Pinpoint Test I |
U0401:86 | Invalid Data Received from ECM/PCM A: Signal Invalid | This DTC sets when the SODL or SODR receives invalid network data from the PCM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no PCM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
U0402:86 | Invalid Data Received from TCM: Signal Invalid | This DTC sets when the SODL or SODR receives invalid network data from the PCM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no PCM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, INSTALL as-built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Configuration (418-01 Module Configuration) . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Side Obstacle Detection Control Module (419-04 Side and Rear Vision, Removal and Installation). |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.