No | REFER to: Instrumentation, Message Center and Warning Chimes (413-01 Instrumentation, Message Center and Warning Chimes) . |
|---|
A8 VERIFY THE BLIND SPOT INFORMATION SYSTEM (BLIS®) IS ENABLED IN THE MESSAGE CENTER
NOTE: Verify a MyKey® is NOT in use.
Navigate to the Blind Spot Information System (BLIS®) menu in the message center and verify the Blind Spot Information System (BLIS®) is ON.
Is the Blind Spot Information System (BLIS®) ON?
Yes | GO to A9 |
|---|---|
No | ACTIVATE the Blind Spot Information System (BLIS®). If the system cannot be activated, GO to A10 |
A9 CHECK FOR CORRECT GEAR INPUT
Apply the parking brake. While monitoring the reversing lamps, move the selector lever (automatic transmission) or gearshift lever (manual transmission) through the entire range.
Do the reversing lamps illuminate only in reverse?
Yes | GO to A10 |
|---|---|
No | REFER to: Reversing Lamps (417-01 Exterior Lighting, Diagnosis and Testing). |
A10 PERFORM THE PCM (POWERTRAIN CONTROL MODULE) KOEO (KEY ON, ENGINE OFF) SELF-TEST
Using a diagnostic scan tool, perform the PCM KOEO self-test.
Are any Diagnostic Trouble Codes (DTCs) present?
Yes | Refer to the appropriate section in Group 303 for the procedure. |
|---|---|
No | GO to A11 |
A11 CHECK THE GWM (GATEWAY MODULE A) CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODES (CMDTCS)
Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Are any Diagnostic Trouble Codes (DTCs) present?
Yes | REFER to: Communications Network (418-00 Module Communications Network) . |
|---|---|
No | GO to A12 |
A12 VERIFY THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) AND SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) CONFIGURATION
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.