Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes | REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing). |
|---|---|
No | GO to B5 |
B5 PERFORM THE PCM (POWERTRAIN CONTROL MODULE) SELF-TEST
Using a diagnostic scan tool, perform the PCM self-test.
Is DTC P0562 or DTC P0563 recorded?
Yes | REFER to PCM DTC Chart in this section. |
|---|---|
No | GO to B6 |
B6 RECHECK THE PCM (POWERTRAIN CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the PMI, or the PMI may not have been carried out.
Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs). Wait 10 seconds. Repeat the PCM self-test.
Is DTC U0212 still present?
Yes | GO to B7 |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
B7 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0212 SET IN OTHER MODULES
Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs). Ignition OFF. Ignition ON. Wait 10 seconds. Using a diagnostic scan tool, retrieve all Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Is DTC U0212 set in any other module?
Yes | GO to B8 |
|---|---|
No | GO to B9 |
B8 CHECK FOR CORRECT SCCM (STEERING COLUMN CONTROL MODULE) OPERATION
Ignition OFF. Disconnect and inspect all SCCM connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.