MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Engine

Is the concern still present?

303-13C Evaporative Emissions - 5.0L

2016 Mustang5.0LReference 751 / 6,619HTML edition
← Chapter contents

pushed-out pins – install new pins as necessary

Reconnect all the SCCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new SCCM MODULE. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation).

No

The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

B9 CHECK FOR CORRECT PCM (POWERTRAIN CONTROL MODULE) OPERATION

Ignition OFF. Disconnect and inspect PCM connector. Repair:

corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary

Reconnect the PCM connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new PCM. REFER to: Powertrain Control Module (PCM) (303-14C Electronic Engine Controls - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS), Removal and Installation).

No

The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

U0164

DTC Fault Trigger Condition-PCM

DTC

Description

Fault Trigger Conditions

U0164 Lost Communication With HVAC

Control Module

The PCM sets this DTC if data messages received from the FCIM through the GWM are missing.

Normal Operation and Fault Conditions

The HVAC control module is housed in the FCIM. REFER to: Communications Network - System Operation and Component Description (418-00 Module Communications Network, Description and Operation).

Possible Sources

Source reference 751

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.