Is DTC P0562 or DTC P0563 recorded?

C5 PERFORM THE PCM (POWERTRAIN CONTROL MODULE) SELF-TEST

Using a diagnostic scan tool, perform the PCM self-test.

Yes	REFER to PCM DTC Chart in this section.
No	GO to C6

C6 RECHECK THE PCM (POWERTRAIN CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)

NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the PMI, or the PMI may not have been carried out.

Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs). Wait 10 seconds. Repeat the PCM self-test.

Is DTC U0164 still present?

Yes	GO to C7
No	The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

C7 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0164 SET IN OTHER MODULES

Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs). Ignition OFF. Ignition ON. Wait 10 seconds. Using a diagnostic scan tool, retrieve all Continuous Memory Diagnostic Trouble Codes (CMDTCs).

Is DTC U0164 set in any other module?

Yes	GO to C8
No	GO to C9

C8 CHECK FOR CORRECT FCIM (FRONT CONTROLS INTERFACE MODULE) MODULE OPERATION

Ignition OFF. Disconnect and inspect all FCIM MODULE connectors. Repair:

corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary

Reconnect all the FCIM MODULE connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for

this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical

Source reference 753

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.