No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
|---|
D25 CHECK THE EXTERIOR MIRROR JUMPER HARNESS
Inspect the exterior mirror jumper harness between the vehicle harness and the mirror motors for:
Open or short circuits Damaged or pushed out pins Corrosion
Is the harness OK?
Yes | INSTALL a new exterior mirror motor. REFER to: Exterior Mirror (501-09 Rear View Mirrors, Removal and Installation). |
|---|---|
No | REPAIR the harness as necessary. If the harness cannot be repaired, INSTALL a new exterior mirror. REFER to: Exterior Mirror (501-09 Rear View Mirrors, Removal and Installation). |
One Or Both Heated Exterior Mirrors Is Inoperative Or Always On (With Memory Mirrors)
Refer to Wiring Diagrams Cell 124 for schematic and connector information.
DTC | Description | Fault Trigger Conditions |
B1163:11 | Left Mirror Heater Output: Circuit Short To Ground | This continuous and on-demand DTC sets if the DDM detects a higher than expected current draw when voltage is applied to the LH exterior mirror heater circuit. |
B1163:15 Left Mirror Heater Output: Circuit Short To Battery Or Open | This continuous and on-demand DTC sets if the DDM detects a lower than expected current draw when voltage is applied to the LH exterior mirror heater circuit. | |
B1164:11 | Right Mirror Heater Output: Circuit Short To Ground | This continuous and on-demand DTC sets if the PDM detects a higher than expected current draw when voltage is applied to the RH exterior mirror heater circuit. |
B1164:15 Right Mirror Heater Output: Circuit Short To Battery Or Open | This continuous and on-demand DTC sets if the PDM detects a lower than expected current draw when voltage is applied to the RH exterior mirror heater circuit. |
Possible Causes
Wiring, terminals or connectors Exterior mirror Door module
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.