Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-10 | C652B-6 |
Is the resistance less than 3 ohms?
Yes | GO to D24 |
|---|---|
No | REPAIR the circuit. |
D20 CHECK FOR VOLTAGE TO THE VERTICAL MOTOR CIRCUIT AT THE RH (RIGHT-HAND) EXTERIOR MIRROR
Ignition OFF. Disconnect: RH Exterior Mirror C626. Connect:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-8 | Ground |
Ignition ON. Select the RH mirror with the exterior mirror selection switch. While pressing the exterior mirror control switch in the up direction, monitor the test light.
Does the test light illuminate only when the exterior mirror control switch is pressed in the up direction?
Yes | GO to D25 |
|---|---|
No | If the test light is illuminated when the exterior mirror control switch is not pressed in any direction, GO to D21 If the test light does not illuminate when the exterior mirror control switch is pressed in the up direction, GO to D22 |
D21 CHECK THE VERTICAL MIRROR CIRCUIT FOR A SHORT TO VOLTAGE AT THE RH (RIGHT-HAND) EXTERIOR MIRROR
Ignition OFF. Disconnect: PDM C652B. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-8 | Ground |
Is any voltage present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.