MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2015–2017 source collection · Additional coverage

Fuel Tank Filler Pipe — Removal

Fuel Tank And Lines - 3.7L Duratec (227kW & 301PS)

Source configuration appliesSource reference 6,223HTML edition
← Chapter contentsManual collection

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .

2. Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect .

NOTE: The supplemental refueling adapter is located in the luggage compartment.

3. Install the supplemental refueling adapter and a 6 ft. length of 5/8 in. semi-rigid fuel drain tube into the Easy Fuel™ (capless) fuel tank filler pipe until the tube enters the fuel tank.

Fuel Tank Filler Pipe — original illustration 1, reference 6223Original colors & callouts · Select to enlarge

NOTE: This step is to remove approximately one-eighth tank of the fuel from a completely full fuel tank and the majority of any residual fuel in the fuel tank filler pipe, lowering the fuel level below the fuel tank filler pipe inlet.

4. Attach the Fuel Storage Tanker to the fuel drain tube and remove approximately one-eighth (approximately 2 gallons) of fuel from the tank.

Use Special Service Tool: 292-00004 Fuel Tanker 100 GPM.

5. Remove the rear wheel on the LH side. Refer to: Wheel and Tire .

6. Remove the retainers and position aside LH rear wheel splash shield aside.

Ford_Mustang_all_2015-2017.pdf · source reference 6223

Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.