Evaporative Emission System Leak Test — Evaporative Emissions - 3.7L Duratec (227kW & 301PS) · Reference 7378

4 Upper intake manifold 5 PCV 6 RH valve cover 7 EVAP canister 8 Fuel Tank Pressure (FTP) sensor and tube 9 Fuel tank 10 Fuel level sensors 11 Fuel tank filler pipe 12 EVAP canister vent solenoid 13 Fuel pump and sender assembly 14 Fresh air hose

Original table alignment retained · Scroll horizontally if needed

DIAGNOSIS AND TESTING > EVAPORATIVE EMISSIONS > ENGINE DIAGNOSTIC

INFORMATION

For PCM DTC, REFER to: ELECTRONIC ENGINE CONTROLS - 3.7L DURATEC (227KW/301PS) .

For driveability symptoms without DTC, Refer to ENGINE CONTROLS - SYMPTOM CHARTS (EXCEPT DIESEL & HYBRID) .

GENERAL PROCEDURES > EVAPORATIVE EMISSION SYSTEM LEAK TEST

Activation

Phase 1 - Leak Verification

1. Run the EVAP Test with the scan tool.

NOTE: Some small leaks may not be detected using the EVAP Test. If the system has passed the test but a leak is still suspected, then proceed to Phase 2.

2. If the EVAP system failed the EVAP Test, then proceed to Phase 2.

Phase 2 - System Leak Check

3. Disconnect the fuel vapor tube-to-EVAP canister purge valve quick connect coupling. Refer to: QUICK RELEASE COUPLING .

Ford_Mustang_all_2015-2017.pdf · source reference 7378

Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.