Ambient Temperature | Resistance |
|---|---|
0-10° C (32-50° F) | 2,782-1,663 ohms |
10-20° C (50-68° F) | 1,837-1,140 ohms |
20-30° C (68-86° F) | 1,260-806 ohms |
30-40° C (86-104° F) | 893-570 ohms |
40-50° C (104-122° F) | 630-428 ohms |
Is the resistance within the limits indicated?
Yes | REPAIR the circuit(s) in question. GO to AB36 |
|---|---|
No | INSTALL a new driver seat cushion blower motor. REFER to: Front Seat Cushion Blower Motor (501-10A Front Seats, Removal and Installation). GO to AB36 |
AB20 CHECK FOR CORRECT BLOWER MOTOR INSTALLATION AND FOR CRUSHED FOAM
Ignition OFF. Remove the driver seat. REFER to: Front Seat (501-10A Front Seats, Removal and Installation). Remove the driver seat backrest cover. REFER to: Front Seat Backrest Cover (501-10A Front Seats, Removal and Installation). Inspect the driver seat backrest for the following:
Backrest blower obstructed Blower filter restricted or plugged Blower motor correctly installed Seat backrest foam pad crushed or restricted
Is the blower motor correctly installed and the foam pad OK?
Yes | GO to AB21 |
|---|---|
No | Correctly INSTALL the backrest blower motor or INSTALL a new seat backrest foam pad. INSTALL the seat. GO to AB36 |
AB21 CHECK CUSHION BLOWER MOTOR CIRCUIT FOR A SHORT TO VOLTAGE
REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Position the driver seat in the vehicle and connect the seat-to-floor connectors. Disconnect: Driver Side Airbag In-line C345. Disconnect: Passenger Side Airbag In-line C219. Disconnect: SCME C3265A. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265A-H | Ground |
Is any voltage present?
Yes | REPAIR the circuit. GO to AB36 |
|---|---|
No | GO to AB22 |
AB22 CHECK CUSHION BLOWER MOTOR + CIRCUIT FOR A SHORT TO GROUND
REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265A-G | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to AB23 |
|---|---|
No | REPAIR the circuit. GO to AB36 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.