Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4368B-3 | C3118-7 |
Is the resistance less than 3 ohms?
Yes | GO to K6 |
|---|---|
No | REPAIR the circuit. |
K6 CHECK THE ELECTRICAL CONNECTORS
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector.
Ignition OFF. Disconnect BCMB C4368B. If DTC B126E:23 or B126E:24 is present, disconnect power window motor right rear C3119. If DTC B126F:23 or B126F:24 is present, disconnect power window motor left rear C3118. Using a good light source, inspect each connector for the following:
corrosion - install new connector or terminal and clean the module pins damaged or bent pins - install new terminals or pins pushed-out pins - install new pins as necessary
Using a suitable mating terminal, check the following connector terminals for deformed or enlarged contacts:
C4368B-3 C4368B-16 C3119-7 C3118-7
Are all connectors free of corrosion, pushed-out pins and deformed or enlarged contacts?
Yes | INSTALL a new right rear or left rear power window motor. REFER to: Rear Quarter Window Regulator Motor - Convertible (501-11 Glass, Frames and Mechanisms, Removal and Installation). |
|---|---|
No | REPAIR the affected connector. Refer to Wiring Diagrams Cell 5 for schematic and connector information. |
Copyright © 2016 Ford Motor Company
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.