MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE
Saved 0

2016 workshop · Body & Paint

Convertible Top Rear Panel Lower Weatherstrip

501-18 Convertible Top

2016 MustangConvertibleReference 1,627 / 6,619HTML edition
← Chapter contentsProcedure contents

501-18 Convertible Top 2016 Mustang

Removal and Installation Procedure revision date: 01/13/2015

Convertible Top Rear Panel Lower Weatherstrip

Special Tool(s) / General Equipment

Electric Drill

Removal

NOTE: Removal steps in this procedure may contain installation details.

Procedure views are with the convertible top in the fully closed position showing tension on the convertible top material, actual position should be approximately 25-50 percent open allowing slack in the convertible top material and other components for serviceability.

1. Open the convertible top approximately 50 percent.

Convertible Top Rear Panel Lower Weatherstrip — original illustration 1, reference 1627Original colors & callouts · Select to enlarge

2. NOTE: RH side shown, LH side similar.

All rivet shavings must be removed from the vehicle and convertible top assembly.

Drill the rivets from the convertible top rear panel lower weatherstrip. Use the General Equipment: Electric Drill

Source reference 1627

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.